This page is for approved wholesale customers only.

This pattern is in English.

The Sequence Sweater is knit from the top down in rib (k1, p1) and the yoke is shaped with raglan increases. The sweater is knit with one strand of Spinni from Isager Yarn and one strand of silk mohair held together. The first part of the yoke is knit flat to shape the neckline. The sleeves are knit on double pointed needles (dpns) or on a circular needle using the Magic Loop technique. The neckband is knit at the end from picked up stitches along the neckline, and it is fold over to result in a double neckband in rib.

Note, the gauge should be measured after blocking. That means that while you knit should get a gauge of around 25-27 sts per 10 cm. This will relax into 22 sts per 10 cm after washing and in use. Knit a gauge swatch and wash and block it before casting on for your Sequence Sweater.

Sizing guide

The Sequence Sweater has an intended positive ease of 13-14 cm built in the pattern, compared to your actual bust measurement. The sizes XS (S) M (L) XL (XXL) correspond to a bust measurement of approximately 85 (90) 95 (100) 110 (120) cm. Measure yourself to find the best size for you before casting on. If you have a bust measurement of 95 cm, you should knit a size M.

Note, your Sequence Sweater will look quite small when you have just finished knitting it, given the size. When you wash, dry and use it, the rib will  “open up” and the gauge should be correct and the sweater will have the right size.

When you wash the sweater and lay it flat to dry, pull it so it obtains the correct measurements and gauge of 22 sts per 10 cm.

Sizes: XS (S) M (L) XL

Bust circumference: 98 (104) 109 (115) 124cm (after wash and blocking)

Length: Measured mid back from the bottom of the neckband: 52 (55) 57 (60) 64cm

Sleeve length: 42 (44) 47 (49) 50cm

Gauge: 22 stitches x 25 rows = 10 x 10cm in rib (k1, p1) in the round on bigger needles after blocking

Suggested needles: 3 mm / 40 cm, 4 mm / 60 and 80-100 cm circular needles, 3 mm and 4 mm double pointed needles (or the required needle size to obtain gauge)

Materials: One strand Spinni from Isager Yarn (50 g = 300 m) held together with one strand Silk Mohair from Isager Yarn (25 g = 212 m) or Brushed Lace from Mohair By Canard (25 g = 210 m) or Soft Silk Mohair from Knitting For Olive (25 g = 210 m) or Silk Mohair from Onion Garn (25 g = 210 m). Calculate using 25 (25-50) 50 (50) 50 g silk mohair and (50) 50 (50) 50 (50) g Spinni for each stripe. Thin elastic band for the neckband. NOTE: the required yardages in silk mohair in the smaller sizes are between 1 and 2 skeins for each stripe.

Colour codes

The Sequence Sweater with the grey stripe is knitted in one thread Merino and one thread Soft Silk Mohair from Knitting For Olive in the following colors:

Mørkegrå + Lakrids

Hvid + råhvid

Perlegrå + Zink

Mørk Okker + Okkerbrun

Mørkegrå + Lakrids

The Sequens Sweater with the purple stripe is knitted in the following colours: 

Grey: Spinni 47 + Silk Mohair 47 from Isager

White: Spinni 0 from Isager + Silk+Kid Mohair råhvid from Onion

Light purple: Spinni 12S + Brushed Lace (Soft allium) from Mohair By Canard

Brown: Spinni 3 + Soft Silk Mohair (okkerbrun) from Knitting for Olive.